Dear aps
thank you very much.
pay attention to this sentence:
If it is then you can ignore the address the logger is reporting and just connect to it using the public address mapped to it.
I do not understood 100%.
what does it mean "ignore the address the logger is reporting"?
Exactly where and which address and how?
Need to delete parameters there or edit.?
Could you specify more detail?
what does it mean "just connect to it using the public address mapped to it"
in a Setting editor - PPP - need to write public IP address
apn name ............................for static IP or for dynamic IP
user name ...........................leave empty
user password.................... leave empty
and dial string .................... *99****1#
and response........................CONNECT
do you mean these or not?
The APN setting normally needs to be set in the modem separately using a terminal emulator and by sending AT commands,, unless you embed the setting into the dial string which is not normally advised.
Normally you will leave the IP address in the PPP screen at 0.0.0.0 which instructs the modem to pick up the address from the network. You should only set a fixed address if specifically told to by your network provider, i.e. to try to force the fixed IP address in the modem.
With the 0.0.0.0 settings the logger will report the IP address it is assigned in the PPP Network Status box once it has connected to the network.