Services Available | |
---|---|
Repair | Yes |
Calibration | No |
Free Support | Yes |
CS215-PWS为带有特殊接头的温度和相对湿度传感器,可连接到PWS100机箱。 使用瑞士制造的元件,加工成的温度和相对湿度传感器,测量结果精确而稳定。CS215-PWS采用SDI-12信号输出方式,可由大多数Campbell Scientific数据采集器来测量。
该版本的CS215温湿度探头,线缆不是尾线方式,而是连接到PWS100机箱的快速接头;线缆长度为 1米。
CS215采用Sensirion SHT75型组合式相对湿度和温度元件,来提供精确而稳定的测量。Sensirion SHT75元件可在野外更换,消除了由重校准产生的下线时间。CS215输出SDI-12信号,可心大多数Campbell Scientific数据采集器来测量。
CS215应该被固定在防辐射罩内,通常为41303-5A。41303-5A 6页防辐射罩为自然通风方式,可固定在主桅杆、横臂或直立塔的立柱上。
Sensing Element | Sensirion SHT75 |
Communication Standard | SDI-12 V1.3 (responds to a subset of commands) |
Supply Voltage | 6 to 16 Vdc (typically powered by data logger’s 12 V supply) |
Typical Current Drain |
|
EMC Compliance | Tested and conforms to IEC61326:2002. |
Operating Temperature Range | -40° to +70°C |
Diameter |
|
Probe Length | 18.0 cm (7.1 in.) including strain relief |
Cable Length | 10 m (33 ft) |
Weight | 350 g (12.3 oz) with 10-m (33-ft) cable |
Relative Humidity |
|
Measurement Range | 0 to 100% RH (-20° to +60°C) |
Output Resolution | 0.03% RH |
Accuracy |
|
Short-Term Hysteresis | < 1% RH |
Temperature Dependence | Better than ±2% (-20° to +60°C) |
Typical Stability | ±1.0% per year |
Response Time with Filter | < 20 s (63% response time in still air) |
Calibration Traceability | NIST and NPL standards |
Temperature |
|
Measurement Range | -40° to +70°C |
Output Resolution | 0.01°C |
Accuracy |
|
Response Time with Filter | < 120 s (63% response time in air moving at 1 m s-1) |
For this version of the CS215 Temperature and RH Probe, the cable has, instead of pigtails, a connector for attachment to the PWS100. Cable length is 1 meter.