Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Can I connect a sensor with analog output 0 - 10V to CR3000?

Phenomics Nov 3, 2015 09:46 PM

Hello All
I have recently purchased a Baumer sonar sensor. It does have an analogue output of 0 - 10V, but I see that the CR3000 datalogger's analog output is rated as 0 - 5V.

Is there a way of connecting the sensor (and getting accurate readings)?

Regards,

GaryTRoberts Nov 3, 2015 09:53 PM

Yes. You can use a voltage divider between the datalogger and the sensor and still get accurate measurements.

Take a look at
https://www.campbellsci.com/vdiv2-1

GaryTRoberts Nov 3, 2015 09:58 PM

Also look at https://s.campbellsci.com/documents/us/category-brochures/b_tims.pdf

* Last updated by: Robin D on 7/5/17 @ 4:58 PM *
Phenomics Nov 3, 2015 10:10 PM

Hello Gary
Thank you for the very fast reply! This is exactly what I need. I have already requested a quote.
Thank you!

Log in or register to post/reply in the forum.