常见问题解答关于我们的产品和解决方案的常见问题

Can eight PT100 sensors be connected to a CR1000 using a 3WHB10K?

Yes. The CR1000 can measure eight PT100 sensors with a 3WHB10K terminal input module. The measurement instructions, however, have to reflect that more than one sensor is being excited with the same excitation channel (MeasPEx argument) in the BrHalf() or BrHalf3W() instruction.

有帮助

常见问题解答主页

相似常见问题解答

How can LoggerNet be upgraded to LoggerNet Admin?
To connect the HMP155A-L to a CR800 or CR1000, should a differential or single-ended channel be used?
Can three-wire PT100 sensors only be used with three-wire half-bridge modules, or can they also be used with four-wire half-bridge modules?
If a device or sensor is not available for selection in the Short Cut program, how can it be added?
To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?
If the message “Clock check started” is followed by the message “Clock check failed,” what does this mean?
Is there a way of configuring the FTP, HTTP, and Telnet services remotely on a CR1000 or CR3000 with an NL115?

常见问题解答 关于我们的产品和解决方案的常见问题

Can eight PT100 sensors be connected to a CR1000 using a 3WHB10K?

相似常见问题解答

常见问题解答关于我们的产品和解决方案的常见问题