这个产品是无效的且被替换: WINDSONIC4-L.
| Services Available |
|---|
概览
The WindSonic was a two dimensional ultrasonic anemometer that output an SDI-12 signal. Our WindSonics are an alternative to traditional mechanical cup and vane or propeller and vane anemometers. They do not have moving parts, which minimizes routine maintenance.
WindSonics are manufactured by Gill Instruments Ltd.
图像
产品规格
- Temperature Range: -35° to +70°C
- Operating Humidity: 0% to 100% RH
- Power Requirements: 9 to 30 Vdc, 40 mA continuous
- Outputs: Polar (direction and speed) or orthogonal (L.C. and L.C. wind)
- Dimensions: 5.6" (14.2 cm) diameter, 6.3" (16.0 cm) height
- Weight: 1.1 lb (0.5 kg)
兼容性
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
数据采集器
| Product | Compatible | Note |
|---|---|---|
| 21X (retired) | ||
| CR10 (retired) | Requires a special PROM. | |
| CR10X (retired) | ||
| CR200 (retired) | ||
| CR205 (retired) | ||
| CR206 (retired) | ||
| CR210 (retired) | ||
| CR211 (retired) | ||
| CR215 (retired) | ||
| CR216 (retired) | ||
| CR23X (retired) | ||
| CR295 (retired) | ||
| CR3000 (retired) | ||
| CR500 (retired) | ||
| CR5000 (retired) | ||
| CR510 (retired) | ||
| CR800 (retired) | ||
| CR850 (retired) | ||
| CR9000 (retired) |
Additional Compatibility Information
The WindSonic is connected to one control port, +12 Vdc, and ground. The SDI-12 instruction is used to collect data from the WindSonic; up to ten WindSonics (each with a unique address) can be connected to one data logger control port.
常见问题解答
WINDSONIC-L: 5
展开全部收起全部
-
Yes, but only with the appropriate CRBasic program. Short Cut does not support that type of programming. The custom program would have to be written by someone at Campbell Scientific, and the client would be charged for the time to write and test the code.
-
Campbell Scientific does not sell an extension cable. A replacement cable can be ordered and built to the desired length (pn 05106CBL-L). This replacement cable has a connector that mates with the connector at the end of the 3 ft cable attached to the 05106-L.
-
The measurement instructions will likely remain the same. However, in addition to the multiplier and offset, the type of pulse may change for the wind speed, and the excitation voltage may change for the wind direction. For an explanation of how the data logger needs to be programmed, see the instruction manual.
-
The short answer is less than 0.01 mA. The wind speed signal requires no power. The wind direction portion of the sensor only uses a maximum of 0.5 mA when excited with 5 Vdc, and then it is only on for 0.016 s for every measurement. When the wind direction is measured every second (typical), the average current drain is less than 0.01 mA.
-
After installing the mounting pipe, place the orientation ring, followed by the wind sensor, on the mounting pipe. Orient the junction box to the south, and tighten the band clamps on the orientation ring and mounting post. Final sensor orientation is done after the data logger has been programmed to measure wind direction as described in Appendix A of the instruction manual.
案例研究
Background In 2022, ECR Medio Ambiente assumed the responsibility of overseeing the structural monitoring installation at......阅读更多