这个产品是无效的且被替换: 05108-L.
| Services Available | |
|---|---|
| Repair | Yes |
| Calibration | No |
| Free Support | Yes |
概览
专为海洋、海岸应用设计，重量轻，耐用，可测量风速风向。制造厂商为 R. M. Young，通过线缆连接Campbell Scientific的数据采集器。
优势与特点
- Waterproof bearing lubricant and a sealed, heavy-duty cable pigtail instead of the standard junction box make it more durable at marine and off-shore locations
- Compatible with most Campbell Scientific data loggers
- Rugged enough for harsh environments
- Constructed with thermoplastic material that resists corrosion from sea-air environments and atmospheric pollutants
- Compatible with the LLAC4 4-channel Low-Level AC-Conversion Module, which increases the number of anemometers one data logger can measure
- Uses stainless-steel, precision-grade ball bearings for the propeller shaft and vertical shaft bearings
- Compatible with the CWS900-series interfaces, allowing it to be used in a wireless sensor network
图像
相似产品
技术说明
05106 采用耐用的抗紫外线的热塑塑料，不锈钢和阳极电镀铝材质。耐热塑料可抗击海洋空气环境的侵蚀，抵抗大气污染。精密级别的不锈钢滚珠轴承用于旋桨轴承和立式轴承。
专为海岸和海洋应用设计，经久耐用，05106采用防水的轴承润滑剂以及密封高性能的尾线代替了标准接线盒。
05106 用四叶螺旋状叶轮测量风速。叶轮旋转产生与风速成正比的频率的交流正弦波。传感器线圈中感应的交流信号由安装在传动轴六极磁铁生成。线圈固定在不能旋转的主安装组件的中部，省去了滑环和电刷。
连接在内部电位计上的机身状的传感器被用来感应风向。数据采集器将已知的精确的激发电压传向电位计元件。输出的模拟电压信号与方位角成正比。
产品规格
| Operating Temperature Range | -50° to +50°C (assuming non-riming conditions) |
| Mounting Pipe Description |
|
| Propeller Diameter | 18 cm (7.1 in.) |
| Overall Height | 37 cm (14.6 in.) |
| Overall Length | 55 cm (21.7 in.) |
| Main Housing Diameter | 5 cm (2.0 in.) |
| Weight | 1.5 kg (3.2 lb) |
Wind Speed |
|
| Range | 0 to 100 m/s (0 to 224 mph) |
| Accuracy | ±0.3 m/s (0.6 mph) or 1% of reading |
| Starting Threshold | 1.1 m/s (2.4 mph) |
| Distance Constant | 2.7 m (8.9 ft) 63% recovery |
| Output |
ac voltage (three pulses per revolution) 90 Hz (1800 rpm) = 8.8 m/s (19.7 mph) |
| Resolution | (0.0980 m s-1)/(scan rate in seconds) or (0.2192 mph)/(scan rate seconds) |
Wind Direction |
|
| Mechanical Range | 0 to 360° |
| Electrical Range | 355° (5° open) |
| Accuracy | ±3° |
| Starting Threshold | 1.1 m/s (2.4 mph) at 10° displacement |
| Distance Constant | 1.3 m (4.3 ft) 50% recovery |
| Damping Ratio | 0.3 |
| Damped Natural Wavelength | 7.4 m (24.3 ft) |
| Undamped Natural Wavelength | 7.2 m (23.6 ft) |
| Output |
|
| Voltage | Power switched excitation voltage supplied by data logger |
兼容性
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
数据采集器
| Product | Compatible | Note |
|---|---|---|
| 21X (retired) | ||
| CR10 (retired) | ||
| CR10 (retired) | ||
| CR1000X | ||
| CR10X (retired) | ||
| CR200X (retired) | ||
| CR206X (retired) | ||
| CR211X (retired) | ||
| CR216X (retired) | ||
| CR23X (retired) | ||
| CR295X (retired) | ||
| CR300 | ||
| CR3000 (retired) | ||
| CR3000 (retired) | ||
| CR310 | ||
| CR500 (retired) | Measurements are typically processed for output with the Wind Vector instruction, which is not present in the CR500. | |
| CR5000 (retired) | ||
| CR510 (retired) | ||
| CR800 (retired) | ||
| CR850 (retired) | ||
| CR9000 (retired) | Measurements are typically processed for output with the Wind Vector instruction, which is not present in the CR9000. |
Additional Compatibility Information
Mounting
The Wind Monitors can be attached to a CM202, CM204, or CM206 crossarm via a 17953 NU-RAIL fitting or CM220 Right Angle Mounting Bracket. Alternatively, the Wind Monitors can be attached to the top of our stainless-steel tripods via the CM216 Sensor Mounting Kit.
Wind Profile Studies
Wind profile studies measure many wind sensors. For these applications, the LLAC4 4-Channel Low Level AC Conversion Module can be used to increase the number of Wind Monitors measured by one data logger. The LLAC4 allows data logger control ports to read the wind speed sensor’s ac signals instead of using pulse channels. Data loggers compatible with the LLAC4 are the CR200(X) series (ac signal ≤1 kHz only), CR800, CR850, CR1000, CR3000, and CR5000.
Data Logger Considerations
The 05106's propeller uses one pulse count channel on the data logger. Its wind vane requires one single-ended channel and access to an excitation channel (the excitation channel can be shared with other high impedance sensors).
Programming
The 05106's propeller is measured by the PulseCount Instruction in CRBasic and by Instruction 3 (Pulse Count) in Edlog. The wind vane is measured by the BrHalf Instruction in CRBasic and by Instruction 4 (Excite-Delay-SE) in Edlog. The measurements are typically processed for output with the Wind Vector instruction (not present in the CR500 or CR9000 but is present in the CR9000X).
视频与教程
常见问题解答
05106-L: 9
展开全部收起全部
-
This depends on what is broken. Typically, Campbell Scientific can repair the unit, and the user does not have to purchase a new one.
-
The short answer is less than 0.01 mA. The wind speed signal requires no power. The wind direction portion of the sensor only uses a maximum of 0.5 mA when excited with 5 Vdc, and then it is only on for 0.016 s for every measurement. When the wind direction is measured every second (typical), the average current drain is less than 0.01 mA.
-
The information included on a calibration sheet differs with each sensor. For some sensors, the sheet contains coefficients necessary to program a data logger. For other sensors, the calibration sheet is a pass/fail report.
-
This depends on the information contained in the calibration sheet:
- If the calibration sheet contains coefficient information, Campbell Scientific keeps a copy, and a replacement copy can be requested.
- If the calibration sheet does not contain coefficients, Campbell Scientific does not keep a copy. It may be possible to contact the original manufacturer for a replacement copy.
-
大多数 Campbell Scientific 传感器的型号中都带有 –L，它表示用户指定线缆长度。如果传感器型号名称列有 –LX (这里 “X” 是其它的某个字符), 那么该传感器需要用户指定长度，但线缆尾端会配有用于某个独特系统的特殊快速接头：
- –LC 表示用户指定线缆长度，所配快速接头用于 ET107, CS110, 或已停产的 Metdata1 系统。
- –LQ 表示用户指定线缆长度，所配快速接头用于 用于 RAWS-P 气象站。
如果一个传感器的主型号数字的后面没有被指定 –L 或其它的 –LX 字符，那么该传感器将具有固定的线缆长度。在产品页面订购栏中 (Ordering tab) 的描述字段的末尾，会列出线缆的长度。例如 034B-ET 型号的描述字段含有信息：Met One风传感器适用于ET气象站，67英寸线缆 (Met One Wind Set for ET Station, 67 inch Cable)。产品按固定的线缆长度做尾端处理，默认是尾线方式。
如果线缆尾端配有用于某个独特系统的特殊快速接头，则型号尾部的字符会指定该传感器用于哪一个系统。例如，034B-ET 型号表明该传感器是一个 034B 且用于 ET107 系统。
- 以 –ET 结尾的型号的传感器配备快速接头，用于 ET107 气象站。
- 以 –ETM 结尾的型号的传感器配备快速接头，用于 ET107 气象站，但它们也含有一个特殊的系统安装支架，在订购一个备件时，所配的支架经常是便捷实用的。
- 以 –QD 结尾的型号的传感器配备快速接头，用于 RAWS-F 快速配置气象站。
- 以 –PW 结尾的型号的传感器配备快速接头，用于 PWENC 预接线机箱或预接线系统。
-
不是每一种传感器都有不同的线缆尾端选项。通过查找传感器产品页面的订购栏 (Ordering tab) 中的两个位置，可以检查某种特定传感器的可用的线缆尾端选项：
- 产品型号
- 线缆尾端选项列表
如果传感器以 –ET, –ETM, –LC, –LQ, 或 –QD 等版本的型号供应，那么线缆尾端选项已经反映在该传感器的产品型号中。例如，034B 以 034B-ET, 034B-ETM, 034B-LC, 034B-LQ, 和 034B-QD 等型号供应。
所有其它的线缆尾端选项，如果可用，会列在该传感器产品页面的订购栏 (Ordering tab) 中的线缆尾端选项 (“Cable Termination Options) 区域。例如，034B-L 风速风向传感器具有 –CWS, –PT, 和 –PW 等线缆尾端选项，显示在 034B-L 产品页面的 订购栏 (Ordering tab) 位置。
注： 当更新的产品添加到我们的库存中时，一般来说，我们会在单个传感器的产品型号下面列出多种线缆尾端选项，而不是创建多个产品型号。例如，HC2S3-L 具有 –C 线缆尾端选项用于连接到 CS110，而我们并没有使用 HC2S3-LC 产品型号。
-
- Using Short Cut, click the applicable wind direction sensor in the Selected Sensors list of the Outputs screen.
- The two output options enabled are Sample and WindVector. Select WindVector.
- The WindVector instruction has output options. Select an option with mean wind direction in it.
-
Campbell Scientific 的很多传感器都有可行的不同线缆尾端处理选项，包括以下几种：
- –PT (–PT w/Tinned Wires，镀锌尾线) 是默认选项，不显示在产品行中，而其它选项会显示在产品行中。线缆末端为尾线方式，可直接连接到数据采集器。
- 在 –C (–C w/ET/CS110 Connector，CS110快速接头) 选项中，线缆尾端所配的快速接头可连接到 CS110 电场计或 ET-系列的气象站。
- 在 –CWS (–CWS 带 CWS900 快速接头) 选项中，线缆尾端所配的快速接头可连接到 CWS-系列的接口。连接到 CWS900-系列接口使得传感器可被用于无线传感器网络中。
- 在 –PW (–PW 带预接线快速接头) 选项中，线缆尾端所配的快速接头可连接到预接线机箱上。
- 在 –RQ (–RQ 带RAWS 快速接头) 选项中，线缆尾端所配的快速接头可连接到 RAWS-P 永久配置远程自动气象站。
注： 线缆尾端选项的可行性因传感器而异。例如，传感器可能会有 无选项、两个选项或几个选项可供选择。如果预期的选项没有列在所指定的传感器中，请联系 Campbell Scientific 的应用工程师寻求帮助。
案例研究
The Delaware Environmental Observing System (DEOS) is a real-time system dedicated to monitoring environmental conditions......阅读更多
The meteorological stations at the Interuniversity Institute for Marine Sciences at Eilat (IUI) in Israel......阅读更多
Campbell Scientific's CR10X is the heart of a unique weather station project installed on the......阅读更多